BlueStar RNB486GV1NG Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
5
INSTALLATION
REQUIREMENTS
1. This unit has been designed to be installed
directly against rear walls and side base
cabinets. A backguard must be used. An
island trim is only to be used in an island
installation. It cannot, however, be installed
directly against tall side cabinets, side walls,
tall appliances, or base cabinets extending
beyond 24”. (see, 'Proximity to Side
Cabinets').
2. The side trims must be at least 11/16" above
adjoining counter top surfaces (see 'Proximity
to Side Cabinets').
3. Any openings in the back wall or floor of the
installation site must be sealed.
4. Electrical requirements: 120 volt, 15 amp,
60Hz properly grounded household current.
The receptacle must be positioned to prevent
strain and physical damage to the power
supply cord.
5. Gas requirements: Natural Gas...5.0" WC; LP
Gas 10.0" WC.
6. Proper ventilation must be installed for this
product. For best results, consult with your
dealer or HVC installer for minimum CFM’s.
7. The installation of this appliance must
conform with local codes, or in the absence
of local codes, with the National Fuel Gas
Code, ANSI Z223.1.
In Canada, installation must be in
accordance with the current CAN/CGA
B149.1 and .2 installation codes and/or local
codes.
NOTE: Be sure to check the rating plate
label located on the left side under the burner
grate to confirm that the appliance is properly
equipped for the gas supply.
WARNING!
ELECTRICAL GROUNDING INSTRUCTIONS:
This unit must be electrically grounded in accordance with local codes, and the National Electrical Code
ANSI/NFPA No. 70, (or latest edition). Installation must be made by a licensed electrician. This appliance is
equipped with a three-prong grounding plug for your protection against shock hazard, and should be plugged
directly into a properly grounded receptacle.
Do not cut or remove the grounding prong from this plug.
In Canada, the installation must be in accordance with the current
CSA C22.1 Canadian Electrical Code, Part 1, and local codes.
**IMPROPER INSTALLATION WILL VOID WARRANTY**
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 31 32

Comments to this Manuals

No comments